Design study starter¶
Use this starter to explore bus dimensions, placement and subsystem choices in a supported two-deck layout. Each design is evaluated with the same mission requirements and the native coupled solvers.
Start a study¶
- In Configure, create a project from Design study starter and save it.
- Open Studies, choose New study, and select the saved project.
- In Inputs, use the subsystem tabs to choose which inputs may vary. The suggested ranges and hardware come from the project and its component catalog.
- Choose a budget. Custom lets you enter a case allowance and active time. Use Use a nominal starter at the top for a populated nominal study, or use adaptive search to explore the selected inputs.
- Review Plan, then confirm the study once to start execution.
The study uses a frozen saved revision. Changes to the project apply when you prepare a new study. Authored requirements and fixed hardware constraints remain in force; a held input can only vary where the model and project allow it.
Review the designs¶
Watch progress and pause or cancel from the study header. In Results, filter and sort the complete comparison, inspect a candidate's evidence, and add designs to a shortlist. Warnings remain visible when recording your selection. Use the export button to retain the complete publication and recorded review.
A completed solver run can still produce an infeasible design. Designs with failed or missing mandatory evidence cannot become a passing selection. Optional uncertainty cases assess the installed nominal hardware; sizing response is a separate comparison.
Native sizing does not require FreeCAD. CAD export is optional. These concept models support trade studies; their assumptions and evidence remain part of the engineering review.