Skip to content

EX13 · Corrected packaging baseline

Examples index · Console starter catalog

Run this example

  1. Open Configure → Load Example. Expand Diagnostics, then choose EX13 · Corrected packaging baseline.
  2. Name the project and run. Keep the starter inputs unchanged for your first run.
  3. Study → Generate CAD is Enabled by default. The server needs a compatible FreeCAD runtime for CAD export; native sizing can run without it.
  4. Validate the inputs, run the study, and follow the active stage in the run monitor.
  5. Open the completed run and inspect the results described below.

Use access and setup if you need a compatible runtime. First Console run illustrates the common loading, validation and execution steps.

Study and results

This is the controlled repair of EX12. Only launch_accommodation.explicit_envelope.maximum_y_m changes from 0.6 m to 1.8 m. The mission, hardware, bus topology, operating assumptions and seed are identical. Open Compare with, verify that single input difference, then inspect Launch, Evaluation and Spacecraft.

Choosing adequate accommodation for a fixed spacecraft is the lesson. It does not satisfy a mission that must retain the original 0.6 m limit; that would need a new spacecraft design and validation. EX05 shows the same change in editable CLI inputs.

Diagnostics and older examples

The previous multi-fault examples remain in the repository for regression tests. Current EX01–EX05 downloads use the maintained designs and refreshed evidence. Existing run bundles are not modified by these repairs; run a fresh example.

Read the engineering assessments alongside the budgets. A complete score or a CAD export does not establish flight qualification; see Evidence and limits.

Next: EX14 · Symmetric deployable arrays · All examples