Skip to content

EX11 · Topology trade: spine

Examples index · Console starter catalog

Run this example

  1. Open Configure → Load Example. Choose EX11 · Topology trade: spine.
  2. Name the project and run. Keep the starter inputs unchanged for your first run.
  3. Study → Generate CAD is Enabled by default. The server needs a compatible FreeCAD runtime for CAD export; native sizing can run without it.
  4. Validate the inputs, run the study, and follow the active stage in the run monitor.
  5. Open the completed run and inspect the results described below.

Use access and setup if you need a compatible runtime. First Console run illustrates the common loading, validation and execution steps.

Study and results

Compare EX10 and EX11 using Placement, Spacecraft, Launch and Compare with. EX10 deliberately reuses EX07's flat baseline. The spine changes the bus from 2.0 × 0.8 × 1.2 m to 1.2 × 0.8 × 2.0 m and changes launch orientation from xyz to yzx, placing body Z along launcher U. Mission, selected hardware, operating assumptions and fairing requirements stay fixed.

The spine's qualification run has about 0.69 m radial diameter margin, replacing the former near-limit orientation. This is modeled envelope margin, not measured installation clearance. The pair changes topology and its launch mounting orientation together; it does not isolate topology alone. EX04 provides the identical pair as CLI downloads and records the controlled input diff.

Read the engineering assessments alongside the budgets. A complete score or a CAD export does not establish flight qualification; see Evidence and limits.

Next: EX12 · Tight-envelope diagnostic · All examples