Skip to content

EX12 · Tight-envelope diagnostic

Examples index · Console starter catalog

Run this example

  1. Open Configure → Load Example. Expand Diagnostics, then choose EX12 · Tight-envelope diagnostic.
  2. Name the project and run. Keep the starter inputs unchanged for your first run.
  3. Study → Generate CAD is Enabled by default. The server needs a compatible FreeCAD runtime for CAD export; native sizing can run without it.
  4. Validate the inputs, run the study, and follow the active stage in the run monitor.
  5. Open the completed run and inspect the results described below.

Use access and setup if you need a compatible runtime. First Console run illustrates the common loading, validation and execution steps.

Study and results

This case completes sizing, placement and CAD but fails the launch-width check check.launch.geometry.v. Its custom envelope is 3.2 × 0.6 × 1.6 m, too narrow for the spacecraft. Open Launch and inspect demand, limit and margin. A missing generic Issue entry does not make a failed engineering check disappear.

EX05 gives the same diagnostic through the CLI. Compare with EX13: only available launch width changes to 1.8 m. Mission, spacecraft, hardware, topology, operating assumptions and seed are identical. The original run must remain ineligible; a crash or missing upstream result is not the intended lesson.

Next: EX13 · Corrected packaging baseline · All examples